Fret Saws: The Ultimate Luthier's Guide & Recommendations

GUITAR FRET SAW WITH SLOT DEPTH GAUGE

Fret Saws: The Ultimate Luthier's Guide & Recommendations When I cut my fret slots I have a piece of fret wire with tangs filed off that I run through the fret to check that the slot is deep enough The

GUITAR FRET SAW WITH SLOT DEPTH GAUGE

tuinhek slot Slots are normally cut to 023 for most fret wire used today Tang measurement varies a bit dependent upon size but it's usually around 116

Some beeswax rubbed on the saw teeth makes for easier fret slot cutting And a depth gauge ensures the slots are cut to the correct depth Small blocks of

fret slot saw Throughout this article I will be using a diameter endmill to cut the fret slots The width of this cutter determines the width of the slot

pop one in a stewmac mini router base with a dremel or foredom, carefully set the depth and carefully run it through the fret slot and you'll