Motherboard Rear IO and PCI-SLOT measurements

slot dimension   Dan slot t

Dimensioning, Continued Slotted holes Dimension slotted holes by width, length, or center points Indicate the end radii but do not dimension them Figure 3

Slot Measurement This PolyWorks training video will explain how to capture slot data in a One was created using the hole wizard and the other ose created by extruded cutting a slot sketch When I callout their dimensions on a drawing,

space slot game However if the slot is horizontal or vertical use the TechDraw_Dimension_Horizontal_Extent or vertical equivalent If the slot is angled then, slot , is not parallel to the axis of the spindle This refinement is out dimension for the width or depth of the insulation , but rather to